View Single Post
  #5  
Old 07-20-2006, 11:18 PM
Keith Tedford Keith Tedford is offline
Senior Member
 
Join Date: Jul 2000
Location: Ontario, Canada
Posts: 1,695
Thanks: 3
Thanked 55 Times in 12 Posts
Default Re: How to tell if trans cutout for 4spd is authen

In the later seventies the 4 speed hole was cut out with a torch. Our Chevelles look the same. There was a copper guide laid on the floor pan to guide the torch. It sure looked home done so it shouldn't be too hard to duplicate. How you are going to spot weld the shifter box on over the hole could be a problem if you are looking for the original look.
__________________
Chevelleless after 46 years......but we did find a low mileage, six speed, silver 2005 Corvette. It will just have to do for now.
Reply With Quote