[BBIGG BLOCK 396]

I could be wrong here,I usually am but I thought that the bench seat handle and the non console handle were basically the same except the curve in the handle on the bench seat was more round to clear the seat.On the console shifter handle it was shaped like the non console but had a slight bend or offset to the side to come up through the console hole,the offset that I am referring to is not the slight offset on the base where the shifter bolts to the body,but just slightly above that about 2 or 3 inches.The offset is not that much but approx about 1 1/2 inch offset Now keep in mind I have not worked on or seen any of these in a long long time but that is what I think I remember,but it very possibly I am wrong.According to my wife I usually am.That offset would be why there is 3 types of handle part #s,one for the bench seat,one for the nonconsole and then one with the offset for the console car.Does this sould logical or do you think I am CRAZY! I know you guys have seen way more of these than I have but I do remember some type of offset on console handles.

Bobby Dodson