Re: Bracket ID help
I can't post a picture diagram,but I can give you some resources that show them.
*P&A 30A,page 7-2P
*P&A 11,page 7-1
*1970-2 Chevelle/Elco/MC Assembly Manual,page 96,A1-2
The only HDWE required are Bolt,Nut,Washer.They bolt to the front perch of the Lower Boxed Control arm,on the inside of the frame,(facing the Driveshaft).Then extend up to the Mid frame support up over the rearend/Pumpkin.
|