[Unreal]

Can't speak to the repop bumper, but I can speak to the repop inner brackets. I have an original bumper, but have been unable to find original brackets (unless I want to take a 2nd mortgage on my house)
The repop brackets are so far (they are OER brand) I figured that maybe the repop bumpers are different than originals, and the brackets were made to fit them. Anyone know?
The ends are straight on the repops, and at about 15 degrees on the originals. When the brackets are installed, they should be level, but the repops cause the bumper to be rotated up about 15 degrees.


I borrowed a set of originals, and used them as a guide to reworking the repops. The brackets are "Z" shaped, so it's not a smple matter to bend them.

I marked the points on the brackets where the bends should be, and then cut through the web of the "Z" between the two bend points. That allows you to bend without warping. Then I welded up the cut and ground/filed it smooth. Haven't installed the bumper yet, as it is at the painter's, but I'm sure it will fit right as I trial fit the bumper using the original brackets.