[COPO]

For the 1st gen. Camaros, Motion typically used standard Hooker headers and then fabricated an "S" pipe to tie into the mid-year corvette side exhaust. There is an article in a '69 CARS magazine which shows this. Another method used was to tap into the side of the header at the point just beyond where the 4 tubes came together and then fabricate a pipe to tie into the side exhaust. A plate was used to block off the header outlet which could be removed at the track for open headers. This set-up was also shown in CARS magazine. I have never seen a header made for 67-69 Camaros to tie into the corvette side exhausts. Hedman made headers for the corvette that hooked up to the side exhaust, but this would not work on Camaros.