View Single Post
  #4  
Old 08-26-2025, 09:13 AM
bergy's Avatar
bergy bergy is offline
Yenko Contributing Member
 
Join Date: Feb 2005
Location: Pennsylvania, Florida
Posts: 2,832
Thanks: 914
Thanked 1,523 Times in 408 Posts
Default

My ‘67 hood pins were installed in the hood leveller location. Factory leveller nut in the rad support was drilled out to accommodate larger diameter hood pins. Early fiberglass hoods were pretty weak down the center. So, you’ll often see the hood pins moved inboard quite a bit.

Picture of the rad support pre-restoration
Attached Images
 
Reply With Quote
The Following User Says Thank You to bergy For This Useful Post:
dykstra (08-26-2025)