08-16-2025, 07:47 PM
|
 |
Yenko Contributing Member
|
|
Join Date: May 2009
Location: Rockford, IL area
Posts: 3,639
Thanks: 6,331
Thanked 3,170 Times in 1,069 Posts
|
|
I was able to easily remove the driveshaft this morning and sure enough the center support was smoked. The bearing was fine but all of the silicone bushing was gone. I don't have the tools to separate the driveshafts and remove the bearing so I will get it off to a driveshaft specialist on Monday. The new bearing I picked up seems to have a smaller ID than the one on the car now so I will have to deal with that too.
Good thing is it did not take long to remove so it should go back easily enough too.
|