Unbelievably, I do not have a 2 1/16 inch hole saw!!!
Guess I have never had to cut a hole for gauges; always used the supplied bracket.
Any recommendations on a quality hole saw?
Not going to waste time hooking up the amp gauge. Besides oil pressure and water temp, was thinking a vacuum gauge, and maybe a fuel pressure gauges; one low pressure set up for carbs, and one high pressure for FI set ups.
Also, just because I already have a spare pair of AFR gauges, I will mount them.
Any other gauges I should consider?
Not looking forward to wiring...
__________________
Don't believe everything you read on the internet ... Ben Franklin
|