View Single Post
  #235  
Old 06-27-2024, 01:56 PM
cook_dw's Avatar
cook_dw cook_dw is offline
Yenko Contributing Member
 
Join Date: Oct 2003
Posts: 4,387
Thanks: 672
Thanked 1,725 Times in 660 Posts
Default

Photos 850 - 851 - Removed the bumper stop and shock body mount and bolts. Before cleaning. Note one bolt failed to have its washer installed from the factory on the passenger side. All other bolts retained their washers.



Photos 852 - 854 - After cleaning and coating them with Cosmoline Rust Veto aerosol.



Photos 855 - Lower bulkhead stamping.

Photos 856 - 857 - Tail pan stamped number.


Photos 858 - 863 - Drivers rear wheel well. Still more cleaning to be done but you hopefully can see the progress.



Photos 864 - 866 - Passenger side rear wheel well


Photos 867 - 869- Trunk floor


Photos 870 - 873 - Reinstalling hardware and brackets



It may not look like it but I am more satisfied with the quarter wells. Note the quarters well lips had been rolled at some point.

Photos 874 - 877 - Driver qtr well


Photos 878 - 880 - Pass qtr well
Attached Images
                             
Reply With Quote
The Following 4 Users Say Thank You to cook_dw For This Useful Post:
1967Z28 (06-27-2024), big gear head (06-28-2024), dykstra (06-28-2024), X66 714 (06-27-2024)