View Single Post
  #30441  
Old 08-05-2022, 03:47 PM
60sStuff's Avatar
60sStuff 60sStuff is offline
Yenko Contributing Member
 
Join Date: Jul 2019
Location: Fremont, Ca.
Posts: 1,185
Thanks: 2,157
Thanked 4,792 Times in 905 Posts
Default Red Plastic Fender Liners

An option on ‘66-‘67 Tempest Series only, code #522.

These Pontiac Red Liners (all 4 fender wells) were much thinner than the Oldsmobile (front 2 fender wells).

The Pontiacs were fastened with sheet metal screws with flat washers to the existing front inner fender skirts and rear fender wells.
The outer stainless wheel opening moulding held the Red plastic outer lip in place.
The holes can be seen on my used set.

The fronts typically show tire wear/stains/rub through from the suspension and turning.

Note, the LH front liner has a square molded area to accommodate the transistor ignition (control amplifier) if ordered.
Attached Images
      
__________________
1965 GTO Unrestored Survivor 389 / 335 4 BBL.
1966 GTO Unrestored Survivor 389 / 360 Tri-Power
Early (63-66) Schwinn Stingrays, all Unrestored Survivors
Reply With Quote
The Following 11 Users Say Thank You to 60sStuff For This Useful Post:
1967Z28 (08-06-2022), 67 Nova Boy (08-06-2022), Dave Rifkin (08-06-2022), grantprix (08-10-2022), gtomike1967 (08-05-2022), Keith Seymore (08-05-2022), olredalert (08-05-2022), Tenney (08-06-2022), X66 714 (08-05-2022), YenkoYS-199Stinger (08-09-2022), Z28Project (08-05-2022)