For those of you with the ET or Cal Custom diff covers...what are you guys using to hold the rubber brake hose fitting atop the diff cover. I connected the hard lines and installed the soft line, but there is no way the typical bracket that bolts to the housing cover will align with the brass end of the soft line?
Here is some of the stuff we did today including cleaning of the sun visors, kick panels, upper pinch weld moldings, cowl ducting, and more. Also installed the rear fuel tank, started on the wiring and installed the rear brakes on the diff c/w hard lines.
Visors and headliner moldings turned out awesome!
The new fuel tank got some original insulators and then went into the car.
Next up we installed the hard lines on the rear axles
They fit great but the soft lines brass fitting will not reach the bracket from the diff cover.
Right side hard lines fit great too.
The issue is with the bracket that bolts to the upper left cover bolt. It won't align with the brass splitter block.
Finally, I got around to the brakes and e-brake cables on the diff.