Thread: The Crusty Cuda: Whole lotta Shakin' (N96) Goin' on!
View Single Post
  #10  
Old 08-30-2020, 08:24 PM
njsteve's Avatar
njsteve njsteve is offline
Yenko Contributing Member
  
Join Date: Nov 2003
Location: NJUSA
Posts: 8,332
Thanks: 8
Thanked 2,658 Times in 823 Posts
Default
I then mock assembled the drums (waiting on front seals to arrive) So I could bleed the brakes. Went through 4 bottles of Dot 5 purple silicone brake fluid just to make sure everything was flushed after I bench bled the master cylinder and reinstalled it. Also waiting on the little $3 rubber grommet that goes on the end of the brake plunger rod before I can final assemble the pedal setup.
Attached Images
   
Last edited by njsteve; 08-31-2020 at 04:24 PM.
Reply With Quote
The Following 10 Users Say Thank You to njsteve For This Useful Post:
427TJ (08-31-2020), big gear head (08-30-2020), Lee Stewart (08-31-2020), L_e_e (08-30-2020), markinnaples (08-31-2020), olredalert (08-30-2020), RPOLS3 (08-31-2020), SS427 (09-14-2020), tunes (08-31-2020), X66 714 (08-30-2020)