[Flying Undertaker]

I used a large sheet of regular writing paper taped to the original factory fender using the swept back eyebrow peak body line from the wheel opening as the upper template line (1/2 of the peak as the upper limit) to the rear of the edge of the fender/door gap at the back off of my original factory fender emblem placement. Punch holes through the paper with a pencil taking care not to move the paper. Put template on new fender at same locations and mark punch holes on fender with the same pencil. Then drill holes minutely oversize as to prevent chipping paint finish. This will duplicate factory original discrepancies of each emblem placement as done on the assembly line. Don.