Here I am rounding out the last of the group. I've made the early Chevelle tabs, the Nova tabs and finally here are the Camaro tabs. Pictured here are both tabs in bare steel and Safety Yellow powdercoat. They will NOT fit the endura bumper.
These are made from steel I had laser cut, referencing some original tabs. The jig I already had form doing these previously. These are excellent copies of the original tabs. You would be hard pressed for anyone to be able to tell once there was any paint on it. Unpainted the heat around some of the laser cuts is the only real tell.
Tabs are $200 plus $14 shipping via USPS flat rate boxes to the lower 48. Contact me at
[email protected].
This is a favorite car of mine and I think the tabs look great on it. Hopefully anyone who has not seen Vince's car will get another look.
For anyone who did not know, here are some examples of the tabs I had made. I only have a few left and planned on bringing them to Carlisle, but if they sell here 1st, then oh well.
Pins in case anyone needs them for these, there is another thread on them.
