[NorCam]

Originally Posted by PxTx

These are off a 50's Vette. Probably the shortest set made at 25" long. They are the later style, cause the wider spring pad and lack of a tail. They are also equal in length. What do those other ones measure without the tail? I can only guess that the unequal set-up was an early thing, before slapper bars were properly sorted.

Looks like I found a duplicate set to your red ones Paul, except for these are yellow. Not sure if they were always yellow but they do appear to have been shaved on the one side just like your red ones. The shaved side will have to mount inboard on my Camaro so that I can use existing shock mount tabs, or I'll need to weld another right front tab if I flip them around to have the shave edge outward mounted towards the tire.

I'm about to strip these and restore them with new color but you now have me thinking Lakewood orange/red which would also match the Lakewood roll bar, bell housing and driveshaft loop all in red? These are 25.25" front to back. I'd like to find another of the early style short snubbers like the one shown below if anyone has some old stock?