View Single Post
  #4  
Old 11-25-2017, 12:12 AM
Lynn Lynn is online now
Yenko Contributing Member
 
Join Date: Feb 2005
Location: Oklahoma
Posts: 7,764
Thanks: 90
Thanked 3,569 Times in 1,505 Posts
Default

Quote:
Originally Posted by Crossbreed383 View Post
Why the conversion?
Was trying to save space. Hence the statement: "not sharing the whole story, suffice it to say I am a dumb a$$"

But, perhaps it will save someone else a headache. I foolishly re-used some low mileage rockers on this build. Every other wear part in the engine was brand new. At least one (haven't removed the other valve cover yet) of the aliging holes in one head is worn badly side to side. The slightly beveled wear pattern on the rocker caused side load on the push rod, and #6 intake push rod bent. Had to remove both rockers and push rods from #6 and drive it home as a V7. Head is now junk if I can't convert. They are just old 76cc truck heads, and not worth another set of valves if I need longer stem valves.

I know I could just buy a set of self aliging rockers and measure the clearance between the little aliging ears and the retainer/split locks. But, if it is too close, then I have a set of useless rockers.
__________________
Don't believe everything you read on the internet ... Ben Franklin
Reply With Quote