Just spoke to a fabricator I know and he said he will make me two plates for the car. He can cut the hole and roll the edges, and he'll then fabricate two sheet metal plates to encompass a Super Shifter or RamRod, and a second that snaps in to put it back to stock using Zeus clips to secure it.
At the same time, he'll fab a remake of the Lakewood 3 point roll bar that I'll secure with one of the new epoxy's so I can heat it up and remove it without any cutting or grinding should I want to take it out down the road. Add new carpet (cheap) and it's right back to stock if I want the stock shifter and console back in there.
Thanks for chiming in Ryan. Now I have to find a nice clean restored shifter as I missed out on Tim's RamRod yesterday.
__________________
I like solid lifter cars, big cams and cars w/ 3 pedals in them. 
Last edited by NorCam; 06-15-2017 at 06:58 PM.
|