[NorCam]

Never looked at the dates and paperwork until tonight but it's all good. Block was magged, bored with torque plates, decked, cleaned, cam bearings installed and it was then greased up throughout. Casting is 3970010 dated F-11-9 with 2482 main caps. Crank is an 1182 turned 10/10 with a couple spots that might need polished after sitting. Pink rods were resized and balanced but he has to find the box with the rods still. Pistons are hypereutectic .030 flat tops so this will likely go together as a spare with a mechanical cam and maybe make 400hp with those 062 heads. The Edelebrock 2913 intake is a far too large for the motor but I'll find another build it'll be used on. Pretty good haul for a gift from a friendly neighbor.