Hmmm, might be having an ohhhhhh moment.
So I'm looking at the N33 tilt wheel page. I can see where that jumper harness in the above link would work. The black wire appears to be for the horn. Still have to figure out what the gray wire is for.
If my thought process is correct, I may have to cut / modify this harness and insert the correct plugs/connectors. Hmmm.
Edit....OK, the jumper harness solves half of the problem. All I need to do next is find that stacked connector (the female connector?) . I could remove the existing 6 pin connector, remove the terminals from it, correctly install them in the female connector, and add the black horn wire. Still need to see where a gray wire fits into this.
__________________
Rick
1966 Chevy Caprice 427-390
2012 Chevy Camaro RS Convertible
Last edited by CC Rider; 05-17-2017 at 04:11 AM.
|