[Ryan1969Chevelle]

Update:

Pictures:-) I am having a hard time posting pictures of "virtual progress" much harder to document than actual progress.

Engine: I plan to visit the machinist this week to pick up scrap and discuss next steps.

Transmission: Nick and I are firming up a plan for a wicked M22Z (3) using a donor case/Trans and have decided to refresh the M22 out of the car with the basic seals, bearings, rebuild kit, etc as it is most valuable as such. Nick may have shared his addiction of Muncies with me:-)

Driveshaft: the shaft is powder coated and I have new u-joints, and strap. I had to verify the spline count on the slip yoke I am buying from Dave Siltman, once I get it I will put it all together.

Flywheel: firming up with Dave that it is a 10.5 inch, 30lb SFI approved steel.

Clutch fork: if Dave finds it, a Lakewood heavy duty fork.

Blow proof bell housing: looking for a used Quick Time or Lakewood......

A whole lotta virtual progress:-) invisible actuality at its best :-)

Ryan