Re: Early SBC Intake Gaskets
I've used various brands of gaskets over the years -- the old Victor gaskets were the cats meow before FelPro came on the market. As far as rear main seals -- it's all in preparation. I have always "dressed" the edge of the main cap and block where they slide into the groove on the seal. You don't want to "shave" and material off the seal during installation. Also, I apply a dab of Hi-Tack to the main parting surface (between cap and block) to prevent oil from seeping between them. Another "trick" is to off-set the seal parting lines -- I've installed them both ways ... doesn't seem to make any difference if seal is installed carefully. If available for your application -- use the one piece pan gasket. This has worked for me on both SBC and BBC engines. TAZ [img]<<GRAEMLIN_URL>>/biggthumpup.gif[/img]
__________________
You've never lived until you've almost died -- for those who fight for it, life has a flavor the protected will never know!
|