[JoeC]

That chrome one does not have the same feet as mine has.
Mine came with a 67 Camaro that was a drag car and the roll bar was said to have been in it.
I never tried to fit it back in though.

That reproduction one had the front plates welded on
The front plates on mine are made with a slip out connection with one bolt through the bar.
The chrome one has similar design.

It looks like you can remove the 3 bar bolts and slip out the main loop of the roll bar but the rear support bar would stay in the car as it has a slip in connection located near the top of the loop

Lakewood had a second 1st gen Camaro roll bar design that was the same but used an additional bar along the drivers side door