[Ryan1969Chevelle]

I got the small repair rings laid out on the bare frame:-)

Measured a few hundred times, used an original frame dimensioned drawing.

All the diagonal measurements look good plus or minus an eighth of an inch.

Plan to try to get these welded Thursday after work........ so I can get the frame back to the media blaster.

I should have shiny parts next week, on my revised schedule I need to be done the frame this month:-)

Making some engine plans, in a couple weeks I will visit FJ Smith in Cayuga, we seemed to be on the same page with my goals and budget and they dyno tune everything (which is one of my main sticking points)

Also inventoried all my new parts:-) one little issue but Inline will fix it up no problem:-) Last time I thought I was missing the tiny U shaped brake lines from the flex line to the wheel cylinders up front and had to force him to hold off till I could check and double check.

Also somehow I bought a tire pressure sticker for a Hurst Olds with 15 inch tires, I can give it away at PSMCDR to the Polyglass Pimp:-)

Ryan