So...........Let me start of by saying "I are Smart".........LOL........The last major thing to do was to get the Heat Exchanger final mounted.......got the brackets made and installed......Then I just had to run the wires from the pump to the Vaporworx controller next to the Battery........So.....The Vaporworx system basically controls how hard the fuel pump works.......instead of the normal Corvette Filter/ Regulator with a return line back to the tank.........This system has a pressure sensor in the fuel line and just runs the pump hard enough to keep the fuel pressure where it needs to be........this is the way GM is now running the fuel system in the new cars........So.....I get it all hooked up and crank the car over to see if it will start.........It cranks over but not even a hint of starting.........Humm !!!!.....Seems the fuel pump isn't working..........Crawl underneath and remove the plug to the pump and hot wire it........Pump kicks on......Humm!!!..........Check the voltage at the controller and call Carl from Vaporworx......I tell him what I'm seeing and he tells me that's not right.....Hummm!!! ........After diagnosing the problem with Carl after many phone calls......He ask's me if I had the Ground wire from the Battery to the controller......Oh.....Do you mean the one I forgot to put on..........LOL......Hooked it up and the car started immediately.........Duhh!!!............Now with the different Mass Airflow Sensor that Edelbrock requires in their system.....I need to get the Tune correct.......Right now the car starts and rev's to 3000 rpm and the fades and shuts off........The tune will correct that........A few wires to neaten up and shes done..........Gonna order the new drivetrain for the 57 Nomad next week...........Gonna be a Busy/ Short winter....LOL
Notice the extra wire.........LOL
All Finished.........Except for the Tune......
Ken