The boy and I installed the pistons and rods today. We each did four. I got the odd side and he did the even side. (Ignore the harmonic damper puller on the crank...it was the only thing I could find with the proper threads to go in the crankshaft. I didn't have a spare balancer bolt anywhere). [img]<<GRAEMLIN_URL>>/smile.gif[/img]
Got the old dial indicator set to TDC. Checked the deck height with using both a flat edge and feeler gauge and then verified with a depth caliper. Got -.016 for both readings on all eight bores. Checked the ring gaps yesterday prior to installing rings on pistons.
Showed him how to measure rotating torque...and told him several more times to keep his left hand off of the measuring indicator....I figured after he got incorrect readings after ten or fiftten revolutions he would eventually listen to me and do it properly without the interfering hand. He finally got a reading of 300 inch pounds. I made him do the math to convert it to foot pounds. (25 lb.ft.)
