Next up is the Hurst shifter. Again, it may be tough to see in the pictures but this shifter was very dirty. The stamped numbers and letters could barely be seen and there is a calcified layer covering all steel parts.
Let's get this thing in the cabinet:
A few minutes later:
Not too shabby! The debris is all gone and only the original plating and some surface corrosion remain. The plastic does not hard the rubber but does clean it.
Here are a couple more videos:
http://vid179.photobucket.com/albums...pseeiltook.mp4
http://vid179.photobucket.com/albums...pskawvoanq.mp4