So........Winter is here and it's time for the "Tweaking"..........The OEM Dash Pad should be coming back from Just Dashes in a couple of weeks........so after installing it I won't be tortured next year looking at that piece of crap reproduction Pad with the ends flipped up because it's too narrow to fit.......sheesh.....you would think by now the aftermarket guy's would have figured Mold Shrinkage into the picture......Just Say'in......Now to deal with the Driveline angles....... After loading the Tremec driveline app on my phone (you use your smartphone as a level and hit the Engine.....Driveshaft....and rear end housing ....and it compares the results and let's you know if everything is good...or Bad) and seeing Red... I decided to get around to starting the process of changing to the -2 pan.....so....After double checking everything....... it ended up with the Drivetrain Angle at 5 Deg down ....... Driveshaft 2 Deg up....... Pinion -1......The car rode well without any Vibration.....But.....at 70 MPH when I let off the gas I could feel where the universals were fighting themselves.........after calculating how much I would have to drop the front of the engine to get to 3 Deg ......It ended up that I would have needed to drop the engine mounts down 1 5/16.......Even with the -2 pan it would be problematic..........so.......After seeing another persons purchase to deal with this issue with parts available from the Driveshaft Shop .......... I called Frank there and we discussed my concerns.....Gave him all the info and he is building me a 3 1/2" Aluminum driveshaft with the trans end having a CV joint and a conventional universal at the rear end........Should be here in a couple of weeks.........Again.....The car drove perfect, but.....I just knew the I didn't hit the "Sweet Spot" with the angles.........This should be the final fix that will let me feel 100% about the Chevelle..................After thinking about it a little more..........everything was built around the engine sitting where it is and lowering it much would have really opened up a can of worms.....This seems to be the simplest and best way to solve that one little issue that was O.K.......But not up to standards........So.....That also means if anyone is going to do a LS swap and will be needing a Holley 302-2 Pan....Baffle system and Oil Pan Gasket.....I just happen to know where there's an extra one for Sale......LOL
