I just got back from installing the new front coil springs and some assorted other parts. The hardest part was installing the new repro upper control arm rubber bumpers. We had to trim the damn things three times to get them to pull through the slots in the control arm. Doesnt anyone make a correct part any more?
I got the new front coils from Coil Spring Specialties.
http://www.coilsprings.com/ They have all the original specs for the cars. I actually had them make my set for a one inch drop in ride height. They do this by altering the wire diameter used in the spring and not by just lopping off a coil. I am glad I got the one inch drop becuase after installation, the front end only dropped about 3/8". We will see how much more the car settles after I put some miles on it.
Here is the generic Classic Industries replacement next to the new coil spring. Slight difference of about an inch and a half uninstalled height. Anyone need the old pair of springs? The car sat at 28-1/2" at the front fender with the old springs on 235/60x15 tires.
And during the process:
