I brought the car to my buddy's garage last night and we put it up on the lift. Lots of loose bolts in the front end, including the subframe to body bolts! At least the oil pan plug was tight. (Grant warned me about how many bolts he had to put back in this thing when he found it).
Looks like its going to need some portions of the rear frame rail on the passenger side replaced. The bottoms of the rails near the front spring perches are notorious weak spots on these cars. Unfortunately, the trucking company used the factory hold down spot in that location when shipping it here and it pulled the metal out of place a bit. This spot is a place where three different pieces of metal are sandwiched together to form the end of the frame rail. It holds moisture and here is the result:
And the broken-out section of the pass side rear frame rail from the tail pipe hanger holding the entire weight of the exhaust due to the broken universal rubber hanger that was carriage bolted to the floor pan above the rusty aftermarket muffler. [img]<<GRAEMLIN_URL>>/rolleyes.gif[/img]
I won't be able to make an accurate assessment of the underside until I can get this thing steam cleaned. I checked with the local equipment rental place near me (the only one that rents the hot water pressure washers) and they quoted me $275 a day to rent the thing. JEEZ! Are the hot water sprayers really that much better than the regular cold water ones? You could almost buy a cold water pressure washer for that price.