[NCGuy68]

Glad to be of help Rick and a little more info to note: The rods and stabilizer shaft for big block are differant then the small block ones. This is noted in the 68 assembly manual under UPC M20 A3-4. The reverse rod and stailizer shaft have very noticeable offsets in them although this isn't shown in the manual. I have never found a differance in the other 2 rods. To my knowledge, the BB rods and shaft have never been repoped. The current repops are correct for SB only. I haven't seen BB rods and a shaft at a swap meet in many many moons and chances are most guys wouldn't recognize them. I wish I had taken photos of all the BB & SB shifters I have rebuilt and restored over the years but most guys only cared about a Hurst. I did however make accurate tracing of the rods, levers, shafts, etc. I often wonder how many of the HIGH $$ restored BB Camaros actually have the corret shifter, rods and shaft in them.