View Single Post
  #28  
Old 03-19-2010, 07:26 AM
Schonyenko2 Schonyenko2 is offline
Senior Member
 
Join Date: Dec 2001
Location: Donahue, Ia. USA
Posts: 2,997
Thanks: 93
Thanked 100 Times in 55 Posts
Default Re: what was the correct Power booster plating

[ QUOTE ]
I think in light of recent situations on this board everyone is a little edgy and am sure Charley meant no harm by that comment. I can assure you if it was a serious comment he would not have been using a stick. I believe right now everyone on here is a little leary about posting much regardless of good or bad for fear of reprisal or negative comments. It is the main reason I have all but quit posting as it is not worth the repercussions. It is a great site but headed in the wrong direction due to a lot of peoples' misunderstandings and negative comments directed at each other. Hopefully things will change in the very near future as this has been my home page for MANY years and I have done nothing but promote this site and it's people over the last many years.

[/ QUOTE ]

Amen brother.
Reply With Quote