View Single Post
  #2  
Old 02-07-2010, 03:40 PM
iluv69s iluv69s is offline
Yenko Contributing Member
 
Join Date: Apr 2007
Location: usa
Posts: 2,511
Thanks: 69
Thanked 324 Times in 137 Posts
Default Re: Made a dolly for early Camaro..thought I'd share

In the front, I made 2 round hole saw holes on the bottom side of the large diameter sq. tubing and 2 smaller 5/8" holes in the top side at the correct width as the factory subframe mount locations. I then bolted thru into the front subframe monuts using factory bushings and bolts. I welded the 2 bars that extend to the rear at the correct distance apart so I could bolt thru the bars into the rear factory subframe mount locations also. I welded sleeves in the bars so they wont crush. I also used factory bushings and bolts in the rear mounts.

In the rear of the car I just made 2 plates with the same bolt hole dimensions as the bottom shock plates. The top plate has the extra hole in the center for the tab that is on the leaf spring. I just sandwiched the 2 plates together with bolts.

I will take a few pics now that it is attached to the car as soon as I dig out of the snowstorm here !!!!
Attached Images
 
Reply With Quote