View Single Post
  #4  
Old 04-29-2009, 05:54 PM
Keith Tedford Keith Tedford is offline
Senior Member
 
Join Date: Jul 2000
Location: Ontario, Canada
Posts: 1,695
Thanks: 3
Thanked 55 Times in 12 Posts
Default Re: What is this SBC intake manifold?

Offenhauser also made a similar intake with three different lids. One was like the Chevy two four setup, one with the single four like this one and then one where you could add three webers or similar carbs. Unless the numbers and letters have been removed, the Edelbrock SY1 and the Offy were clearly identified, as was the Chevy intake.
Check this out. It too has the square indent and the long narrow one on the opposite side of the carb flange. http://victorylibrary.com/graphics/SY1.JPG
__________________
Chevelleless after 46 years......but we did find a low mileage, six speed, silver 2005 Corvette. It will just have to do for now.
Reply With Quote