Forum: Supercar/Musclecar Discussion
01-19-2025, 02:10 PM
|
|
Replies: 0
Views: 257
|
|
Forum: Ebay & other seen ads section
01-16-2025, 09:57 PM
|
|
Replies: 1
Views: 486
|
|
Forum: Ebay & other seen ads section
01-16-2025, 01:11 PM
|
|
Replies: 7
Views: 894
|
|
Forum: Member's Rides
01-15-2025, 02:53 AM
|
|
Replies: 317
Views: 245,169
I was able to finish of the rear quarter trim...
I was able to finish of the rear quarter trim this evening. Acting on a tip from a conversation I had with a local body and paint guy he suggested that the trim clips behind the rear door panels...
|
|
Forum: Supercar/Musclecar Discussion
01-15-2025, 01:56 AM
|
|
Replies: 23
Views: 1,567
my new playtoy
Ive always wanted a Fox convertible 5 speed and I just scored this. 20k mile completely original right down to the air injection system, exhaust and even original spark plug wires. The rare factory...
|
|
Forum: Supercar/Musclecar Discussion
01-13-2025, 09:30 PM
|
|
Replies: 11
Views: 993
|
|
Forum: Chevrolet
01-13-2025, 07:48 PM
|
|
Replies: 39
Views: 2,819
|
|
Forum: Member's Rides
01-13-2025, 12:07 AM
|
|
Replies: 250
Views: 132,192
Both the tabs of the clutches as well as the...
Both the tabs of the clutches as well as the clips that hold them in the diff carrier were badly worn. Between the tabs and the clips as much as .050inch. I was getting several degrees of free play...
|
|
Forum: Supercar/Musclecar Discussion
01-12-2025, 01:00 PM
|
|
Replies: 165
Views: 82,563
|
|
Forum: Member's Rides
01-12-2025, 03:19 AM
|
|
Replies: 317
Views: 245,169
Made some progress today.........didn't get...
Made some progress today.........didn't get started until after lunch but was able to get both fender and door trims swapped out - so I'm 2/3 done as I just have the rear quarters left to do. Also...
|
|
Forum: Ebay & other seen ads section
01-11-2025, 03:28 PM
|
|
Replies: 10
Views: 769
|
|
Forum: Ebay & other seen ads section
01-11-2025, 02:28 PM
|
|
Replies: 7
Views: 1,332
|
|
Forum: L78/L89 specific Forum
01-11-2025, 05:05 AM
|
|
Replies: 15
Views: 6,533
Gears
Nope the car was sourced riding on a ten bolt with the 12 bolt factory rear thrown in the cabin. The Gears were swapped out in 1983 rebuild of the rear, & rear has been Re-Rebuilt in 2024 keeping a...
|
|
Forum: Lounge
01-09-2025, 12:16 PM
|
|
Replies: 18
Views: 1,188
|
|
Forum: Parts/Memorabilia - Sold listings
01-08-2025, 12:29 AM
|
|
Replies: 0
Views: 220
NOS GM 3896929 350/300HP camshaft
FS: One NOS GM 3896929 350/300HP hydraulic flat tappet camshaft.
This part is new in the original tube and has never been installed.
I believe this has basically the same ratings as the low HP...
|
|
Forum: Lounge
01-07-2025, 08:18 PM
|
|
Replies: 39,073
Views: 11,748,450
|
|
Forum: Day 2 stuff-modified cars
01-06-2025, 10:58 PM
|
|
Replies: 11
Views: 1,698
|
|
Forum: Misc. Dealers
01-06-2025, 03:07 PM
|
|
Replies: 106
Views: 231,973
44-201
i check randomly still nothing
|
|
Forum: Mopar
01-05-2025, 04:14 AM
|
|
Replies: 29
Views: 3,394
|
|
Forum: Chevrolet
01-04-2025, 11:08 PM
|
|
Replies: 36
Views: 4,518
|
|
Forum: Ebay & other seen ads section
01-04-2025, 04:34 PM
|
|
Replies: 1
Views: 428
|
|
Forum: Lounge
01-02-2025, 10:42 PM
|
|
Replies: 7
Views: 667
El Camino. goodbye old friend
This chapter of the story starts like this:
"A one eyed drag racer from Arkansas...."
Sounds like a joke, right?
Nope. Sold the El Camino yesterday. Had it advertised on CL. I really...
|
|
Forum: Lounge
01-02-2025, 04:16 PM
|
|
Replies: 18
Views: 3,963
|
|
Forum: Lounge
01-01-2025, 12:52 AM
|
|
Replies: 12
Views: 836
Friends
I want to convey best wishes for 2025....
Friends
I want to convey best wishes for 2025. I wish you good heath, great happiness and maximum fulfillment for the entire year.
Your Health is the most important part. Don’t hesitate to get...
|
|
Forum: Lounge
12-31-2024, 04:45 PM
|
|
Replies: 12
Views: 836
|
