BB Intake 3885069 Identification
 

Anyone know the application for BB aluminum intake 3885069? I found one doing some Spring cleaning and am curious of its aplication and a ballpark value. The only problem is it looks like someone removed the center divider. Thanks in advance.

Re: BB Intake 3885069 Identification
 

Came in three different designs.
3 hole closed Plen,2 hole closed Plen and an open Plenum on:
*1966 Pass. & Corvette w/427~425HP,& L-78 Chevelle.
*1967 L-88 427~435HP Corvette,& L78 Chevelle-Camaro.
*1968 early Pass.w/427~425HP,& early L78 Chevelle-Camaro-Chevy II,& L-88 427~435HP Corvette.

ONLY L-88 Corvette used the open Plenum w/divider cut out at a 45° angle.

Re: BB Intake 3885069 Identification
 

I just bought another one for $300.........Pricing seems to run from $250 - $400

Ken

Re: BB Intake 3885069 Identification
 

I would say pricing on a ncie one would be closer to $450-$600.


Jason

Re: BB Intake 3885069 Identification
 

thanks guys https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: BB Intake 3885069 Identification
 

[ QUOTE ]
I would say pricing on a ncie one would be closer to $450-$600.


Jason

[/ QUOTE ]

Looks like Kwizz just bought a junk one! https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

Re: BB Intake 3885069 Identification
 

[ QUOTE ]
[ QUOTE ]
I would say pricing on a ncie one would be closer to $450-$600.


Jason

[/ QUOTE ]

Looks like Kwizz just bought a junk one! https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

[/ QUOTE ]

Pleunum dividers gone on the $300 one, but ....that can be fixed https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

Ken https://www.yenko.net/ubbthreads/imag...mlins/flag.gif

Re: BB Intake 3885069 Identification
 

They can be had cheaper, but the market seems to have gone up in general.


Jason

Re: BB Intake 3885069 Identification
 

How can you tell if the plenum divider removal was factory or by an owner? Anyone have pics?

Re: BB Intake 3885069 Identification
 

Here's a pic of an original, as cast, 069/093 intake without plenum divider. You can see that there never was a divider, and is not an angle cutout.
There may be other versions.

http://i36.photobucket.com/albums/e4...numbers030.jpg