ZL1 block found
 

i have found a ZL1 block 3946052 it has a rod that has blown # 7 and #8 cylinder wall the sleevs have been removed on those 2 , and has a small crack on the lifter valley , part 3 is 3946052 can anyone tell me what i should pay for a block of this condition??

Re: ZL1 block found
 

1500.00 TO 2500

Re: ZL1 block found
 

Barry buy it for me at 1500.00 i give you a 10K finders fee... https://www.yenko.net/ubbthreads/imag...ns/shocked.gif

Re: ZL1 block found
 

now can it be repaired and who is can i have fix it its just the bare block

Re: ZL1 block found
 

so what your saying is around 3 g's for the block would be fair even needing all those repairs

Re: ZL1 block found
 

hey buddy i dont know much about the block and dont want to buy it if its going to cost a fortune any help or advice in this matter

Re: ZL1 block found
 

Is it a 69 dated block? A competent machine shop should have no problen repairing the block. I think $3K would be a great price for you.

Re: ZL1 block found
 

i guess i should get it than just not sure what it will cost to repair it , i guess i can also use it as a coffee table till than , just joking

Re: ZL1 block found
 

Plan on thousands not hundreds to fix. There are many things that need to be looked at other than the physical repairs. Ive even had a block that physically looked good after repair but the cam geometry was off center and the bores not straight and it would eat cams and lifters one after the other. Couldnt get anyone that wanted to touch fixing it at any price,and those few guys were fixing blocks blown in half for other customers.

Re: ZL1 block found
 

for $3000.00 make sure they throw in a couple of good bottles of wine !!!

http://i134.photobucket.com/albums/q...ngineTable.jpg