1967 396 parts needed
 

I am trying to help out a friend with his parts hunt (yet another L78 Camaro owner). He needs a lot of drivetrain parts at the moment, for the heads he will take either type. The date codes below are generic month/week all parts needed are 1967 dates. If you have any of the parts or leads please send me a PM.-

3902406 4 Bolt 396 block cast 04A through 05E
3919840 Heads cast 05A through 05E
3904391 Heads cast 03A through when they ended in May
3869978 3 deep groove crank pulley (cast iron)
3906656 2 deep groove water pump pulley
3873847 Deep groove power steering pulley (cast iron 3 spoke)
3885069 Aluminum intake Cast 03A through 05E
3909880 Right side exhaust manifold same dates
3909879 Left side exhaust manifold same dates
3910 Carb 03C through 06A will take a 3911 instead
1111170 Distributor 03A through 06A
12 Bolt Camaro traction arm mono leaf Posi rear prefers 3.73, 4.11 or 4.56 but will consider all

In short if you have an entire dated motor it would save him a lot of time hunting down the pieces.

Thanks guys,

Mike

Re: 1967 396 parts needed
 

Forgot the water pump-

3856284 Casting dates 03A through 05E

Re: 1967 396 parts needed
 

Bueller....Bueller?

Someone has to have some of these parts.

Re: 1967 396 parts needed
 

Mike, youve already talked to the guy that has 85% of those parts https://www.yenko.net/ubbthreads/imag...mlins/grin.gif

Re: 1967 396 parts needed
 

I have a 1107365 starter dated 7F12. If you're interested send me a PM. What is the trim tag date?

Re: 1967 396 parts needed
 

[ QUOTE ]
Mike, youve already talked to the guy that has 85% of those parts https://www.yenko.net/ubbthreads/imag...mlins/grin.gif

[/ QUOTE ]

And talked and talked and talked and... The phone bill is starting to hurt at this point.

Mike

Re: 1967 396 parts needed
 

I have a block the date on the pad is T0420EU there is also a vin still on it

Re: 1967 396 parts needed
 

John,

Thanks. If it is a four bolt block he will be interested. If it is a two which I think all EU 350hp engines were he will wind up passing on it. He is not dead set on a specific date for the block but it does need to be a four bolt 406 cast block. All I can say is he is a picky guy.

Thanks,

Mike

Re: 1967 396 parts needed
 

[ QUOTE ]
I have a 1107365 starter dated 7F12. If you're interested send me a PM. What is the trim tag date?

[/ QUOTE ]

Martin,
Sent you a PM.
I'll buy the starter.
Thanks!!!
Jeff

https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: 1967 396 parts needed
 

Sent you a PM.