1962-64 Impala (B) body bucket seat frames, rebuilt
 

$400 plus shipping and insurance, if desired.
If interested, send me your zip in a PM and I'll get measurements, weight and shipping estimates from UPS and FedEx, or postal if preferred.

These frames were sand blasted and rebuilt by Paul Stensland from Sioux City, IA and purchased thru the 348-409 forum. I bought them for my '62 SS as the car came with '65 seats and I discovered that while installing new upholstery on them. Obviously, I never did swap these frames into the car and that was sold 18 months ago.

As seen, they have acquired a little surface rust from sitting now, but have any/all required replacements springs and come with the paper covered, wire listings, ready to paint with Rust-Oleum and upholster.
They do have some stampings but are faint and hard to read.
I have done a little research and these should be the same for other GM B body cars of the same era, but I don't know that for certain and no guarantees. Do you our own research if interested for other than Chevrolet cars.


https://www.yenko.net/forum/cache.ph...2FDSC00880.JPG


https://www.yenko.net/forum/cache.ph...2FDSC00881.JPG


https://www.yenko.net/forum/cache.ph...2FDSC00884.JPG


https://www.yenko.net/forum/cache.ph...2FDSC00883.JPG


https://www.yenko.net/forum/cache.ph...2FDSC00882.JPG


https://www.yenko.net/forum/cache.ph...2FDSC00885.JPG


https://www.yenko.net/forum/cache.ph...2FDSC00887.JPG


https://www.yenko.net/forum/cache.ph...2FDSC00888.JPG


https://www.yenko.net/forum/cache.ph...2FDSC00889.JPG