Help to make a dolly for a 67 Camaro shell..pics?
 

I bought some square steel stock and I am going to make a rolling dolly for my 67 Camaro shell for when I remove all the parts. I don't want to reinvent the wheel and I would appreciate some ideas and better yet a few pics !! Any good ideas out there?? or is there a link of an old thread that someone can hook me up with?

Thanks Guys!! https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: Help to make a dolly for a 67 Camaro shell..pics?
 

I've never taken a close at these set-ups, but this dolly/jack-up to rotisserie system looks really cool and simple!!

http://williamsbcr.com/67Rotisserie2_043.jpg

http://williamsbcr.com/67RotisserieOutside1_040.jpg

http://williamsbcr.com/67Rotisserie4_035.jpg

Re: Help to make a dolly for a 67 Camaro shell..pics?
 

Bye bye trim tag.

Re: Help to make a dolly for a 67 Camaro shell..pics?
 

Please show close up of rear brackets/arms engaging spring eye holes......Did you make special bushings for those holes or just use spring rubbers ????

Maybe original question was looking for body cart, not rotissiere????

Re: Help to make a dolly for a 67 Camaro shell..pics?
 

I was thinking of a body cart....in order to paint the shell with no obstructions..and also it is a lot less room in the garage....I hope someone can help with that

I actually had a rotisserie...

and Chuck I made the rear brackets. I started with sq tubing about 10 " long that fit over the existing two 'arms' of the rotissirie and welded stop bolts. I welded I believe 2" sq tubing perpendicular to extend under the two framerails...and then welded vertically (2) 1/4 " plates with drilled holes to simulate the shackles.... I re-installed the bushings and with bolts attached the cars like that.

It worked great...I sold the rotisserie or I would send pics...hope that helps though...

Re: Help to make a dolly for a 67 Camaro shell..pi
 

http://www.camaros.net/forums/showthread.php?t=163374