Pulley ID
 

Can anybody identify this chevy pulley - 3756328.? I think it is a small block crank of some sort.? Thanks

Re: Pulley ID
 

It is a Crankshaft pulley used on all 1958-61 Corvettes & 1962 Corvette w/o Spcl. Hi-Perf engine.

Re: Pulley ID
 

Rick what is this Case iron 3 hole pulley. Front reads SF2, back reads CAIN 2056-6

Re: Pulley ID
 

Hmmmmmmm...Nothing conclusive there.
Can you measure the inside & outside diameter,shaft diameter & groove width?
Is it a single groove?

Re: Pulley ID
 

pic enclosed Kim

Re: Pulley ID
 

pic 2

Re: Pulley ID
 

The hole diam. 1"1/4

Re: Pulley ID
 

What's the overall diameter of the pulley?

Re: Pulley ID
 

6" 5/8s https://www.yenko.net/ubbthreads/imag...iggthumpup.gif

Re: Pulley ID
 

Looks like the one Tommy K bought at VF a couple of years back. Probably for a '68 COPO Nova! https://www.yenko.net/ubbthreads/imag...mlins/wink.gif

Re: Pulley ID
 

Kim
Very difficult to say right now what yours is,but based on the pictures and measurements,it looks like it's a crankshaft pulley/balancer for a 1964-5 Passenger car 6 cyl. w/o P/S or A/C.

Re: Pulley ID
 

NAAHHA https://www.yenko.net/ubbthreads/imag...mlins/haha.gif

Re: Pulley ID
 

I am cleaning my garage looks like it's going to trash pile. Thanks Rick

Re: Pulley ID
 

[ QUOTE ]
Looks like the one Tommy K bought at VF a couple of years back. Probably for a '68 COPO Nova! https://www.yenko.net/ubbthreads/imag...mlins/wink.gif

[/ QUOTE ]

I hope it is COPO but it looks like chevy truck to me, small block 69/70.