Pad #?
 

Does this pad look right. 67 Chevelle, 11A car. 396-325 car??

Re: Pad #?
 

Can't tell much from the picture, I bet the 030 is from an engine rebuilder. Many would stamp a code on the pad for warranty reasons.

Re: Pad #?
 

EK is L35 396/325 w/ a glide..

Are the Vin stamping fonts supposed to be this big...these appear almost as big as the Build/Suffix fonts?.

I agree the 030 is probably a rebuilders note...maybe noting 30 over?.

Good luck!.
https://www.yenko.net/ubbthreads/imag...mlins/grin.gif
~ Pete

Re: Pad #?
 

What bothers me is difference in hight of suffix letters?

Re: Pad #?
 

I had a 67 Chevelle a couple of years ago...same engine/trans...Fremont,CA car....the stamping was similar but the "7" for the year was kind of floating off to the side...I think it was discussed here and others had seen similar stamps...maybe it makes what assembly plant installed the engine...

wilma

Re: Pad #?
 

[ QUOTE ]
Does this pad look right. 67 Chevelle, 11A car. 396-325 car??

[/ QUOTE ] I bet $100.00 the guy that stamped it was at your house for a few hours before he did it! https://www.yenko.net/ubbthreads/imag...mlins/haha.gif https://www.yenko.net/ubbthreads/imag...lins/beers.gif https://www.yenko.net/ubbthreads/imag...lins/beers.gif https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: Pad #?
 

[ QUOTE ]
What bothers me is difference in hight of suffix letters?

[/ QUOTE ]

I agree Kim but I am no expert on these. It looks suspect https://www.yenko.net/ubbthreads/imag...lins/dunno.gif

Re: Pad #?
 

It looks like a legit pad stamp to me. Sometimes they would stamp the first letter of the suffix at one point and than later the other after they knew what the horsepower was. With the 409 in my 65 Biscyane, Tonowanda stamped the J first and the A is lower, so I think it was done once they knew it was a 400 horse engine and not a 340.
Steve

Re: Pad #?
 

The car is on E-bay and a friend is looking at it!! https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: Pad #?
 

Happy St.Patricks Day Kim O'Howie

http://www.pingetcetera.com/uploaded...lep-747292.jpg

Re: Pad #?
 

It's not unusual to have the letters hand stamped after the build date. They still used large VIN numbers in 1967, that is OK.

Re: Pad #?
 

Thanks Guys https://www.yenko.net/ubbthreads/imag...lins/beers.gif https://www.yenko.net/ubbthreads/imag...ns/scholar.gif

Re: Pad #?
 

Well regardless of what people think.. I'm just happy to see people asking questions before buying/bidding.. I just hope that any potential buyer gets confident answers before buying. too much fraud going on to not feel really good about what you're buying.

Mike

Re: Pad #?
 

And a good day to you Sir. https://www.yenko.net/ubbthreads/imag...lins/beers.gif https://www.yenko.net/ubbthreads/imag...iggthumpup.gif