INTAKE AND CARB
 

Just bought an intake 396356 and carb is 3969898,list 4492.Does anyone know what motors they might be for?Thanks

Re: INTAKE AND CARB
 

70 ls6 auto trans..i assume thats a typo and the intake is a #569 ?

Re: INTAKE AND CARB
 

3963569 Square Port Intake,
70 Camaro/Nova, L78
70-71, Chevelle, LS6
71, Corvette, LS6


3969898 Holley Carb (List 4492)
70 Camaro/Chevelle, 396/454, auto

Re: INTAKE AND CARB
 

I checked the #'s again and they was 396356.I was told it was of a 70 camaro and was removed in the early 70's.

Re: INTAKE AND CARB
 

Well missed the 9 again.Could this intake have been used with 074 heads?Thanks guys

Re: INTAKE AND CARB
 

I believe there were a limited number of aluminum head L78 Chevelles made in 70....that intake was also used on 71 LS-6 Corvette..Colvin's book shows the engine codes. Sent you a PM..

wilma

Re: INTAKE AND CARB
 

No 1971 LS-6 Chevelles produced for public consumption.
Those 1st 90 days only production 18 1970 L-89 Chevelles used the 842 Aluminum heads,not 074.

1970 L-78 Camaro-Nova-Chevelle & LS-6 Chevelle used that #4492 when equipped w/TH400 trans.,that were NOT sold brand new in the state of Calif.,Nevada,and certain areas of Montana.
What is the date code showing on your #4492 carbs air horn?

1970 L-78 Chevelles used that Hi-Rise intake also.
What is the date on the #569 intake?..Does the intake have the cylinder No. on each runner?

Re: INTAKE AND CARB
 

Where are the dates located on the intake and carb?

Re: INTAKE AND CARB
 

DeWayne,

The intake date in on the underside lowered cross-over
section. It will be something like: 3.21.69

Also, the Holley numbers will be on the front of the airhorn
( drivers side ). This is a vertical face that is in the
aircleaner region.

Steve

Re: INTAKE AND CARB
 

mr70,are you sure no 71 Chevelle LS6's? I remember a light blue white stripe car I ran across in 76 that was said to be a LS6.I remember hearing a production # in the teens.

Re: INTAKE AND CARB
 

If you saw that around the Virginia/N.Carolina area,I'm pretty sure that was a dealer transplant.Sounds like the same one Sonny & Elmer saw back then too.
Marty S. tested a 71 LS-6 Mule in his magazine in 1971,but no FACTORY assembled ones have been proven today.
---------------------
http://img.photobucket.com/albums/v6...sbearslogo.gif
They're On The Move..

Re: INTAKE AND CARB
 

The transplant scenario is likely,but you never know.

Re: INTAKE AND CARB
 

Rick,

Let me see if I remember this:

No 1970 LS-6 Corvettes - right?
No 1971 LS-6 Chevelles?

If I'm not mistaken, I've seen technical listing for LS-6
application for both cars for both years. More folk-lore?

Steve

Re: INTAKE AND CARB
 

I wouldn't exactly call it folklore,but technical materials were printed before the cars were assembled and made a reality.
I believe Chevrolet had ideas to assemble these two cars for public release,but they never fruitioned once their respective production lines started.
------------------
http://img.photobucket.com/albums/v6...sbearslogo.gif
They Will Rein In Arizona..

Re: INTAKE AND CARB
 

Folklore may be the LS7 chevelles. https://www.yenko.net/ubbthreads/imag...emlins/eek.gif There are 2 brothers that drag race in DIV-1. The Abbazia Bros from Conn. I believe they built an LS-6 1971 chevelle and NHRA accepted it for B/SA. So https://www.yenko.net/ubbthreads/imag...lins/dunno.gif