The Supercar Registry

The Supercar Registry (https://www.yenko.net/forum/index.php)
-   Supercars/Musclecars-For Sale (https://www.yenko.net/forum/forumdisplay.php?f=81)
-   -   70 Camaro RS Z/28 (https://www.yenko.net/forum/showthread.php?t=88717)

lbnaz 10-05-2006 07:37 AM

70 Camaro RS Z/28
 
1 Attachment(s)
Hello, this is the car that was talked about under the discussion page that I bought and am now selling. Its a 70 RS Z/28 with 66529 original miles and a clean box A AZ title. I bought it from the 2nd owner who bought it in 73 and did the modifications to the motor then parked it in the sun in 1978 to drive VW's. I have not tried to fire it. There are some wires that will need to repaired prior from pack rats eating them. Only the harness from the fire wall to the headlights and plug wires repalced. Its a numbers matching motor minus the intake, carb, distributor, and exhaust manifolds. It has the original M21 with the vin stamped on it and the original 12 bolt 373 posi rearend stamped COZ. It has the original 837 alternator, 418 starter, B70 772 fan, radiator, fan shroud, pdb, and water pump. The interior is all original but toasted from the AZ sun. The dash guages and original AM radio are in good shape the sun did not hit them. The interior is dry rotted and the dash pad is shot beyond recognition or repair. The floor pans still have the original red oxide paint on them under the car except for two very small rust lines under the rear seats. The original exhaust tips and single muffler are still under it. The rockers are solid as well as the door bottoms. The trunk pan is solid except for one pencil size hole under the passenger side tray. The rear bumper guards are missing but you can see where they were. The worst area on the car is the front pillars by the windshield which has rust in the pillars and also where the window sits and the rear window area which I consider pretty much shot. I was able to stick my pocket knife through in a couple areas through the area between the chrome trim and the body. The car has body damage on the drivers rear and drivers fender which is minor and I have photos. The spare with the 5/8" oval and the polyglass is included. When I bought the car it had US mags on it. I put a set of wheels on it that have the 13/16 oval with nice BF Goodrich tires on it and rings and caps. I'm sure I've left something out in describing it so please ask or call. I can take any angle photo you would like. I like this site and I am offering it here first. I will donate funds to the site when it sells. The price is 13500 US funds. I would like some parts but hate to part it out. Thanks, Larry. 520-349-2337.

Charley Lillard 10-05-2006 07:41 AM

Re: 70 Camaro RS Z/28
 
Seems like a very fair price. Would make a good Z28 project for someone.

lbnaz 10-05-2006 03:33 PM

Re: 70 Camaro RS Z/28
 
1 Attachment(s)
Photo of the front right angle.

lbnaz 10-05-2006 03:35 PM

Re: 70 Camaro RS Z/28
 
1 Attachment(s)
Rust rear window.

lbnaz 10-05-2006 03:37 PM

Re: 70 Camaro RS Z/28
 
1 Attachment(s)
Rust left pillar.

lbnaz 10-05-2006 03:38 PM

Re: 70 Camaro RS Z/28
 
1 Attachment(s)
Dented fender.

lbnaz 10-05-2006 03:38 PM

Re: 70 Camaro RS Z/28
 
1 Attachment(s)
Dented quarter.

lbnaz 10-05-2006 03:39 PM

Re: 70 Camaro RS Z/28
 
1 Attachment(s)
RS front end.

Hylton 10-07-2006 07:52 PM

Re: 70 Camaro RS Z/28
 
Fair price from a fair guy. I have dealt with Larry before and he is straight up honest.

WILMASBOYL78 10-08-2006 02:48 AM

Re: 70 Camaro RS Z/28
 
A refreshingly honest presentation of a "project" Camaro...these original solid lifter cars are getting harder to find. A lot of work but the driveline appears to be intact..that is half the battle..rust issues are minor compared to what we see in the NEast. Hope someone takes it on and gets her done. Good luck with the sale.

wilma

mmcporter 10-08-2006 03:26 AM

Re: 70 Camaro RS Z/28
 
I agree--refreshingly honest is the best way to describe this....I wish I could do the work...good luck with the sale

lbnaz 10-08-2006 07:28 AM

Re: 70 Camaro RS Z/28
 
Hello, I brought the car inside on my lift. The vin is on the oil filter and transmission. I have date codes of everything that is on the car. I have photos of the entire underside of the car. I am posting a few of them but have plenty more if you need more. There is a scattershield on it instead of a bell housing that I saw on the lift. I appreciate the response and comments. If it does't sell I'll shelf it until later. Thanks, Larry.

mmcporter 10-08-2006 07:39 AM

Re: 70 Camaro RS Z/28
 
Larry,

The link to the pics doesn't work. Not sure if it's a Yenko.net problem or if it's on your side.

lbnaz 10-08-2006 08:01 AM

Re: 70 Camaro RS Z/28
 
I tried several times to post and its not working I'll try tomorrow or email for photos. Thanks, Larry.

mmcporter 10-08-2006 10:54 PM

Re: 70 Camaro RS Z/28
 
It sounds like the picture problem is with this site, not your postings in particular.

lbnaz 10-09-2006 03:16 PM

Re: 70 Camaro RS Z/28
 
1 Attachment(s)
photo

lbnaz 10-09-2006 03:21 PM

Re: 70 Camaro RS Z/28
 
1 Attachment(s)
Another one

70-SS/RS-L78 10-13-2006 05:32 AM

Re: 70 Camaro RS Z/28
 
I totally agree, It needs work but if you don’t mind getting dirty and you have time This is a winner.
Larry, Does the car have any Paperwork?

69LM1 10-13-2006 06:00 AM

Re: 70 Camaro RS Z/28
 
I have a friend (craig) that has a dog 71SS w/ a 72 402. He's been drooling over my 70Z, so I turned him on to this one.

He is really excited and says that Larry seems to be a great guy.

I also turned craig onto yenko.net and he will be joining soon.

https://www.yenko.net/ubbthreads/imag...ins/3gears.gif

lbnaz 10-15-2006 11:23 PM

Re: 70 Camaro RS Z/28
 
Hello, thanks for all the comments and input. The car has sold to the above mentioned post. I will be donating to the site when I find out how. If you read this Charlie let me know the procedure to make a donation. Until the next one Thanks again, Larry.

69LM1 10-25-2006 05:47 AM

Re: 70 Camaro RS Z/28
 
Car was picked up yesterday. On it's way to craig (my buddy). Should be here by the end of the week.

https://www.yenko.net/ubbthreads/imag...lins/beers.gif


All times are GMT. The time now is 10:39 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.


O Garage vBulletin Plugins by Drive Thru Online, Inc.