The Supercar Registry

The Supercar Registry (https://www.yenko.net/forum/index.php)
-   Supercar/Musclecar Discussion (https://www.yenko.net/forum/forumdisplay.php?f=79)
-   -   YH wheel help (https://www.yenko.net/forum/showthread.php?t=176300)

bbjohnny 08-04-2023 01:30 PM

YH wheel help
 
1 Attachment(s)
I have a YH wheel that has a 27 stamped in it for a day of the month but seems to be missing the month stamp. I am looking for 2/27 wheels. Were there other months that produced wheels on the 27th? It has the correct center for the earlier wheels. Thanks!

Jonesy 08-05-2023 03:34 PM

They made 1-27 and 2-27. I would suspect this is a 2-27 wheel as I have seen February wheel stampings drift all over the place.

enio45 08-13-2023 06:09 AM

in the pic u can make out the "2" ...faintly - but there - good rare date Feb wheels

bbjohnny 08-14-2023 07:06 PM

I still can't see the 2! Thank you for everyone's help!

Lynn 08-14-2023 07:25 PM

Me either.

Jonesy 08-14-2023 08:03 PM

2 Attachment(s)
I see it. More of the bottom of the 2 shows than the top if you look closely.

Lynn 08-14-2023 08:11 PM

Sure enough.
Almost as hard to find as characters on the rough casting above the oil filter from 1969.

AnthonyS 08-14-2023 08:18 PM

I can see a "2" now too... good eye!

Jonesy 08-14-2023 09:33 PM

I dont know why but this week of 2-27 had a guy stamping wheels all over the place. I know there is a wheel out there where the K19 2 27 YH is all on the right side of the valve stem hole.:blush:

Mr70 08-14-2023 11:32 PM

Proof that Marty Feldman worked for Kelsey-Hayes Wheel Inc.

enio45 08-15-2023 01:07 AM

I can also technically be 12 27 YH

the only other month that uses the 2 in the date range.....i would have to look at the stampings to see how the 2 and possible a 12 lines up - but yes, it is all over the place on this wheel....either dates are good dates - 2-27 being the top of the list of rarity IMO

also - as we know the "2" is suppose to one on the left side of the valve stem hole!! then a big space for the date (on the right side of the valve stem hole)

enio45 08-15-2023 01:14 AM

Any possibility to get a light media clean on the stampings?


All times are GMT. The time now is 09:29 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.


O Garage vBulletin Plugins by Drive Thru Online, Inc.