1967 Z28 Fan
 

Hi All,

Is this a correct fan for a '67 Z28? It has 5 blades with 4 flat rivets on each blade. There is also a "W" stamp on the unit.

What is the approximate value for the unit?

Thank you,
Dan

http://img.photobucket.com/albums/v4...psfznsjxqv.jpg

http://img.photobucket.com/albums/v4...pspyschgob.jpg

http://img.photobucket.com/albums/v4...pso6n1unry.jpg

http://img.photobucket.com/albums/v4...psuwlllt8f.jpg

Re: 1967 Z28 Fan
 

wrong clutch i believe and u have to measure the bolt center to center.....

size matters

Re: 1967 Z28 Fan
 

Thanks EM

I know the clutch is not right. Good eye.

What's the measurement I should be looking for?

Dan

Re: 1967 Z28 Fan
 

the fan is the small one too

Re: 1967 Z28 Fan
 

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: MosportGreen66</div><div class="ubbcode-body">Thanks EM

I know the clutch is not right. Good eye.

What's the measurement I should be looking for?

Dan </div></div>3.25&quot;

Re: 1967 Z28 Fan
 

Hi Guys,

The center of the bolt whole to the end center hole is just shy of 3 inches... What application would this be to? It does have the front and the H on the front side of the fan.

Best,
Dan

Re: 1967 Z28 Fan
 

here is a pic of the correct one http://i161.photobucket.com/albums/t204/rare4k/198.jpg[/img]

Re: 1967 Z28 Fan
 

Re: 1967 Z28 Fan
 

Re: 1967 Z28 Fan
 

Re: 1967 Z28 Fan
 

A lot of fans have the H and FRONT stamped on them. I think the H may be a manufacturers mark. The 3&quot; bolt pattern fan is a popular fan used throughout the Chevrolet lineup. The base of the clutch usually has a date stamped on it. Check yours, its probably a late 60's date.
The above fan is the 67 z/28 fan and has those same markings, but the bolt pattern is 3.25 inches and 4 rivets per blade. I have seen 3&quot; bolt pattern fans same as yours with 5 rivets. That style seems to be later like 1970 and on.

Re: 1967 Z28 Fan
 

I believe the fan Dan has was used on lower performance applications in the mid 60s like a 63 or 64 327/300hp, etc.

Jason

Re: 1967 Z28 Fan
 

I think it's an RPO K02 fan that could even have been ordered on a 327 2-bbl, if desired.

Re: 1967 Z28 Fan
 

The 3&quot; 5 blade 4 rivet fans were used on all cars with K02 and also any SB or BB car that had air conditioning. I believe the 5 rivet blade was used 1965 and earlier, and I can't recall ever seeing a 66 or later car that didn't have a 4 rivet. They are pretty common. I have sold decent units in the past for $100-150.

Re: 1967 Z28 Fan
 

I believe the 'H' was for the manufacturer, Hayes-Albion.
Excellent article on fans and clutches at CRG here: http://www.camaros.org/coolingsystems.shtml#fan