Re: Air Cleaner Lid
 

Still a little glitchy today too. https://www.yenko.net/ubbthreads/imag...mlins/wink.gif

Re: Air Cleaner Lid
 

Does any one have an original lid to get exact measurements from? If mine is the same, I want to have the right verbiage for Ebay. https://www.yenko.net/ubbthreads/imag...lins/smile.gif

Re: Air Cleaner Lid
 

Kevin, 1967z28 (Jon) posted the correct dimensions for you in a previous post above.

Re: Air Cleaner Lid
 

Mark, yes I did see that, I was looking for the height, filter dia and distance from filter edge to outside edge measurements.

Re: Air Cleaner Lid
 

Kevin,

A friend of mine had a cowl plenum aircleaner without a lid and bought a lid like the one you have and it flat out did not work. Having said that, I will give you the information you are looking for.

Height: 15/16"
Filter diameter: 13 13/16"
Filter edge to outside edge of base: 1 1/8"
Base diameter: 16 1/8"
Lid diameter: 16 13/16"

I hope you and others find that information helpful.

-Jon

Re: Air Cleaner Lid
 

Once again Jon you are the go to guy on these early Zs. Thanks again.

Re: Air Cleaner Lid
 

Jon, much thanks! Too bad my lid is just a little bit bigger on every measurement https://www.yenko.net/ubbthreads/imag...lins/frown.gif looks like I just have a junk lid. Thanks for the help!

Re: Air Cleaner Lid
 

Glad to be of some help even though it did not result in a match for Hugger 69 Copo's friend. Maybe one of the fiberglass repro lids would work on a temporary basis until an original was found.

-Jon