Re: Neat Machining Video
 

Yes Ken, the coating(s) you are referring to are actually
only a few microns thick. Normally, these coatings embed
partially into the substrate of the tool steel ( carbide ).
The faster you run them, the better they cut.
Sounds contradictory, but it's true.

Steve

Re: Neat Machining Video
 

In case you didn't look closely, this is just one of the lug-nuts off Ken's Biscayne he recently completed....

Re: Neat Machining Video
 

[ QUOTE ]
In case you didn't look closely, this is just one of the lug-nuts off Ken's Biscayne he recently completed....

[/ QUOTE ]


Too funny https://www.yenko.net/ubbthreads/imag...lins/beers.gif