Re: New Motor
 

Bill, the only thing you might consider is using some oval port heads instead of the 840's. For a street driven car the low end torque is much better. A good set of oval ports with a professional valve job will really make the motor fun. Keep the compression reasonable so you can utilize pump gas. You didn't say anyhing about what cam you have or might use on the rebuild. Lots of good stuff out there today depending on your budget. If you like solids, the L78 "163" unit is hard to beat. Good luck.

wilma

Ps let me know if you need some oval port heads, I have a couple of sets in the shop.

Re: New Motor
 

I would sell what you have. Buy the crate motor and pocket the diff. https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: New Motor
 

And I'll bet you know someone who would buy all that "Old Stuff". https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

(Like you need any more.............. https://www.yenko.net/ubbthreads/imag...-I-Have-It.gifhttps://www.yenko.net/ubbthreads/imag...ns/worship.gif)

Re: New Motor
 

[ QUOTE ]
I would sell what you have. Buy the crate motor and pocket the diff. https://www.yenko.net/ubbthreads/imag...lins/beers.gif

[/ QUOTE ]I don't think you really mean that. Unless........he would sell to you! https://www.yenko.net/ubbthreads/imag...mlins/hmmm.gif https://www.yenko.net/ubbthreads/imag...mlins/haha.gif

Re: New Motor
 

Why take the chance of blowing up a 512 block and 840 heads. Just go buy a 454 build it up with oval ports. My gibb nova was a oval port 427. 500 hp on the dyno. https://www.yenko.net/ubbthreads/imag...iggthumpup.gif PS I have 40 big blocks laying around now. I don't need anymore. https://www.yenko.net/ubbthreads/imag...lins/beers.gif