Re: "Mindbender" '68 Phase III story
 

[ QUOTE ]
Butternut Yellow with a Black stripe...

[/ QUOTE ]

I can name that tune in two notes. See pic. https://www.yenko.net/ubbthreads/imag...iggthumpup.gif

Re: "Mindbender" '68 Phase III story
 

I'm unsure if I'll mix in the bumble-bee stripe or not... I'll have to mess around with PaintShop first to see how it looks.

I'm picking up my stinger hood on Saturday from Rick's First Gen... they have the one from that guy in NC that everybody recommended. They said that they just got new ones in and they are even higher quality then before.

Re: "Mindbender" '68 Phase III story
 

That Motion car was a very cool looking car----How far along are you with your Motion project?

Re: "Mindbender" '68 Phase III story
 

Looks like that 68 is an original big block car from the pictures. You can see the big block heater box. Gotta love those huge tires sticking out.

Re: "Mindbender" '68 Phase III story
 

Yeah the Mallory coil is right above the box--And this car is using the Mallory CD ignition box---

Re: "Mindbender" '68 Phase III story
 

Boy I hope I am not seeing what I think I see? Looks like the old '66 Nova rearend with bolts holding the lower plates to clamp the leaf springs without a U-Bolt over the axle!

I remember a guy here that will never walk without pain because he hit 3rd gear in his 2 month old 350hp '66 Nova and the rear end twisted completely out of the wields at almost 100mph. Totaled him and the car. Chev even went back and redid all the cars they sold with a recall and retro fitted them with a Ubolt over the axle. Very dangerious without them.

Pantera

Re: "Mindbender" '68 Phase III story
 

I had the same problem with the first ladder bars that were first installed on my car,they were welded to the axle,--snapped the ears connected to the axle--they came out with bolt over ladder bars later, but it was decided to go with ET bars with steel bushings---

Re: "Mindbender" '68 Phase III story
 

Here's a photo of the early NMW bars used-- https://www.yenko.net/attachments/122128-Scan0008.jpg

Re: "Mindbender" '68 Phase III story
 

How wide is an L-60 tire https://www.yenko.net/ubbthreads/imag...ns/naughty.gif ?

Re: "Mindbender" '68 Phase III story
 

[ QUOTE ]
That Motion car was a very cool looking car----How far along are you with your Motion project?

[/ QUOTE ]

Click here to see the progress: '68 Camaro.

Right now it has a small block. In September I will upgrade to a period correct 454 and a period incorrect Gear Vendor overdrive (most people won't be able to see that anyway).