Re: Anyone know this car?
 

I looked at a few 68 Corvette VIN's and they are in the 8S4xxxxx range as well so it sure looks like that engine is from a 68 Vette.

Re: Anyone know this car?
 

I don't think he's saying anything about being a supercar. He states the original motor and parts go with the car. The motor is a 350 that looks correct I think the car is a steal. https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: Anyone know this car?
 

That's exactly what he's said in his add. "Converted" it's a clone. It would be a fun driver & I like it too https://www.yenko.net/ubbthreads/imag...iggthumpup.gif

Re: Anyone know this car?
 

OK, I didn't know which direction the seller was going with the car. I thought he might be trying to pass it off as an original "converted" 427 car from B/M, Dana, or Yenko.

Someone is going to get a good buy on the car, especially when the original "numbers matching" 350 comes with it. https://www.yenko.net/ubbthreads/imag...iggthumpup.gif

Re: Anyone know this car?
 

[ QUOTE ]
I looked at a few 68 Corvette VIN's and they are in the 8S4xxxxx range as well so it sure looks like that engine is from a 68 Vette.

[/ QUOTE ]
Here are the full numbers sent by the owner of the car via e-mail...Hopefully the guy who owns the vette that this motor came out of see's this...Im thinking of bringing this one home...Anyone near there to take a look at it? https://www.yenko.net/ubbthreads/imag...lins/beers.gif
Sam
<<<< numbers are TO430IU - 18S418456-BLOCK # 3935139 MANIFOLD # ENDS IN69 AND
CARB # IS 3418 ALL THE PULLYS ARE NOS DEEP GROVE THE CAR IS A REAL SS/RS
HIGH PERFORMANCE WITH A FACTORY TRACTION BAR.>>>